top of page

Our 2+1 Bed & Table is a great solution for anyone that has a 2+1 rear seat set-up where the "+1" seat only reclines. This is usually found in the early T5.1 & T5's.


Simply remove the single seat either onsite or before you leave home. When you're ready to use the bed just slide out the small table stowed underneath and attach it to the frame using our quick & easy thumb turns. Recline the remaining back seats and unfold the platform to create a full width double bed ready for any adventure. When not in use the bed conveniently folds up behind the back seats enabling everyday use of the van without compromising on space. When folded down the bed acts as a parcel shelf allowing you to not only utilise the full height of the van but also double up as a handy platform.

Easily installed utilising existing Volkswagen floor lashing points and seat belt mounts. No drilling is required.


This bed comes fully carpeted. Please see our colour options above.


Please note:

We are excited to say that we recently enhanced the design of our standard & 2+1 SWB Beds by developing a new ‘wing’ fitting. This will replace the existing dog leg that you will have seen in our images. We’re excited about this development as we feel it makes our Bed even better!


The wing improves the look of the Bed, it makes it easier to store when out of the Van (due to the wing being easily removable and the frame is then less intrusive when, for example, standing up in storage) and it increases the integrity of the Bed as it’s made from a folded 5mm steel plate.


We’re confident you’ll agree with the tweak of our design but please get in touch if you have any concerns or questions.

SWB 2+1 Bed & Table / Platform - Fully Carpeted

SKU: 0003
    • The height of the bed is 475mm from the floor to the underside of the frames.
    • When the bed is folded up you are left with a 700mm gap from the edge of the bed to the tailgate or barn doors.
    • When not in use the small table sits on brackets under the bed.
bottom of page